In order to improve the production efficiency of the cone crusher, it is necessary to reduce the failure rate of the cone crusher, and the failure rate is low, so that the cone crusher can continue to operate normally. It does not need to be shut down for inspection and time is spent on repairs.
Therefore, the production efficiency of cone crushers must be improved. Must avoid equipment failure?
 

The cone crusher is a common crusher on the market. The cone crusher can process a variety of ore materials, especially hard rock materials. It has the advantages of long life and large output.
What matters should we pay attention to in daily use?

1. Check before starting to start operation after confirming that it is normal. 　　
2. When starting the main motor, turn off the disconnect switch and the oil switch in sequence. When stopping, the oil switch and isolating switch should be closed in sequence. When the host is still running, it is strictly prohibited to cut off the working power supply. 　

Jaw crusher is an indispensable equipment for many ore production lines. Its efficiency and advantages are obvious to all after years of practice. However, jaw crushers mostly crush ore with higher hardness. If they are not properly maintained, they will be severely shortened. The life of the crusher will also increase the cost of the entire production line. Zhongxin has many years of experience in crusher production. The following is an introduction to the maintenance tips of the jaw crusher.

Cone crushers play a pivotal role in industrial production, and they also play an important role in people’s lives. Therefore, for customers, when choosing a cone crusher manufacturer, they should make a good selection and consider their later Loss is reduced to low dye, so how can I choose a cone crusher that satisfies myself?

Hydraulic cone crusher is a kind of crushing equipment with relatively advanced structure. It can be widely used in many areas of crushing operations such as mines, constructions, road repairs, etc. It also has the advantages of large crushing ratio, high operation efficiency, and uniform product particle size. Liked by a wide range of users. Some friends of Ran Jin reported that after using the cone crusher for a long time, the discharge was too slow. Here, the editor will briefly talk about the reasons for the slow discharge of the hydraulic cone crusher during operation.