Cone crusher crushing ratio of large productivity
Author: Time：2018-07-24
cone crusher is mainly composed of frame, horizontal shaft, moving cone, balance wheel, eccentric sleeve, upper crushing wall, lower crushing wall, hydraulic coupling, lubrication system, hydraulic system and control system. Cone Crusher is an * high-power, large crushing ratio, high productivity hydraulic crusher.
Crushed crusher crushing machine in the production process in order to prevent the feed material falls within the bearing, made of high manganese steel cover to cover it. Top cover can be replaced at any time. The main shaft is equipped with a moving cone, the working surface is also set with high manganese steel liner, lining and cone in order to make close contact, in both zinc injection, and bolt compression. The lower end of the shaft is inserted in the side oblique hole of the eccentric bushing. The inner and outer surfaces of the bushings are embedded with a wear-resistant bearing alloy lining. They are housed in a central sleeve. The large bevel gear is fixed on the bush and meshes with the small bevel gear. The latter through the drive shaft and reducer motor driven, so the sleeve within the spindle that is eccentric cyclical movement, so that the material from the * of the ring-shaped feed inlet in the fixed, moving cone between the broken. Broken material directly from the cone between the bottom of the discharge. The width of the discharge port can be adjusted by adjusting the tapered nut.
Home
Products
Case
News
About us
Service
Contact us
