Zhongxin machine, let the machine change the future!
Home > News > How to reduce the unnecessary wear of the jaw crusher

How to reduce the unnecessary wear of the jaw crusher

Author: Time:2019-07-05
The jaw crusher is an important mechanical equipment for the crushing of ore. The jaw crusher may have some wear during use. In order to minimize the loss of the machine, it is necessary to insist on scientific selection of the model; It is reasonable to use and select materials. Of course, the maintenance of the ore crusher, everyone also needs to pay attention. Xiaobian is here to talk about how to reduce the wear of the jaw crusher.

There may be some problems in the jaw crusher during use. For example, in the structure of the jaw crusher, the wear of the static and static jaws can cause the crusher to fail to operate normally and lose the crushing capacity; the contact between the jaw plate and the machine surface is not stable; The eccentric shaft speed is too fast, and the broken material can not be eliminated, resulting in blockage of the crushing chamber and wear of the jaw plate; the angle between the movable jaw and the fixed jaw is too large, exceeding the normal range; the strength of the jaw and its own strength Wear resistance and poor impact resistance.

Xiaobian reminds the majority of users to pay attention to the new installed jaws must be fixed tightly installed, and the surface of the machine is in stable contact. A layer of plastic material can be placed between the surface of the jaw plate and the machine; each batch of material entering the crusher must be sampled. Once the nature of the material changes, it is necessary to change the crusher in time. The parameters are matched with the incoming materials; the jaws must be made of materials with high hardness, wear resistance and strong resistance; the worn jaw crusher jaws should be replaced in time.

In the process of crushing ore by jaw crusher, it should be noted that the jaw crusher should be started after normal operation; the crushed material should be evenly added into the crushing chamber, and side feeding or stacking should be avoided to prevent unilateral Overload or overload; under normal conditions, the temperature rise of the bearing does not exceed 35 ° C, the maximum temperature does not exceed 70 ° C, if it exceeds 70 ° C, it should be stopped immediately, it should be checked in time; before stopping, the feeding should be stopped first, to be broken The motor can be turned off after the crushed material in the chamber is completely discharged.

Online message

write down your requirement and contact details in the following form to get the latest price of this product within one day!

  • Name
  • Email*
  • Message*
Get quote online
Tel:+86-371-67660555Call now